×

PC-Based Power Quality Analyzer Using ESP32 and Op-Amp Signal Conditioning

Author : Aarnav Rao, Antara Prabhune, Rajdeep Choudhuri, Dr.Thamilmaran Journa Name: International Journal of Science, Engineering and Technology Volume: 14 issue: 5 Year: Volume-14-issue-5 Views : 3
Abstract:
This paper presents the design of a low-cost, PC-based power quality analyzer intended for educational experimentation with low-voltage AC signals. The prototype combines an ESP32 microcontroller, LM358-based analog signal conditioning, a series RC test load, a low-side shunt resistor for current sensing, USB serial data transfer, and a Python analysis application. The voltage channel scales a nominal 10 V peak-to-peak, 50 Hz source using an inverting amplifier, while the current channel measures the voltage developed across a 1 ? shunt placed in series with a 220 ? resistor and a 10 µF capacitor. The software is designed to estimate RMS voltage and current, frequency, real and apparent power, power factor, phase difference, and waveform spectra. Analytical calculations provide a reference operating point for validating the prototype. At the time of writing, the current-conditioning output has exhibited an approximately flat response and the complete measurement chain has not yet been calibrated; consequently, no unverified experimental performance is claimed. The paper documents the architecture, circuit design, acquisition method, analysis procedure, preliminary calculations, and validation plan.

Related Indexing Platform

Indexed

Leave Your Comment

Related Reviewers

Chat with Expert