Experimental Investigation and Process Optimization during CNC Turning of AISI D3 Steel
Author :
Amit Thakur, Tanvir Singh, Jatinder KumarJourna Name:
International Journal of Science, Engineering and Technology Country :
IndiaVolume:
12 issue:2 Year:2024 Views : 386
Abstract:
The study delved into assessing the performance disparities between uncoated and TiNAl-coated carbide inserts during CNC turning of AISI D3 Steel under dry conditions, examining varying cutting parameters such as spindle speed, feed rate, and depth of cut. Process performance was gauged through surface roughness, Material Removal Rate (MRR), and Tool Flank Wear (TFW). Employing an L18 orthogonal array, experiments were conducted and optimized using the Taguchi method and subsequently validated with a Weighted Sum Model (WSM) approach. Findings underscored the significance of all cutting parameters in enhancing surface quality and MRR, with spindle speed emerging as the most influential contributor, accounting for 73.34% of the impact. Taguchi optimization recommended wet cutting conditions with a spindle speed of 800 rpm, feed rate of 0.16 mm/rev, and depth of cut of 1.3 mm for minimal surface roughness. Notably, machining factors like spindle speed, feed rate, and depth of cut played pivotal roles in achieving maximum MRR, while cutting environment, spindle speed, and feed rate significantly influenced TFW. Optimal responses were attained through WSM, with MRR at 420.165 m/sec, surface roughness at 0.75 µm, and TFW at 0.024 µm, utilizing cutting parameters of 1200 rpm, 0.12 mm/rev, and 1.3 mm, respectively. Confirmatory experiments validated substantial improvements in responses when employing the recommended parameter combinations.