Design Development, Sheet-Metal Forming Simulation and Progressive-Die Manufacturing Study of Hinges for Industrial Control Cabinets
Author :
Mr. Girish Deshmukh, Associate Professor Dr. Vishnu S. Aher, Associate Professor Dr. Dipak S. BajajJourna Name:
International Journal of Science, Engineering and Technology Volume:
14 issue:4 Year:Volume-14-issue-4 Views : 12
Abstract:
Hinges control the alignment, opening behaviour and service life of industrial control cabinet doors, yet sheet-metal hinges must be formed without local failure on a production tool. This paper presents the design development, forming simulation and manufacturing study of two in-house sheet-metal hinge designs produced on a progressive die. Three-dimensional CAD models were used to build a multi-operation (OP10–OP30) forming model in STAMPACK, and the final-operation results of the hinge geometry for which complete outputs were available are evaluated through thinning, forming-limit (FLD) safety-zone and FLD map-centre contours. Closed-form relations for percentage thinning, true thickness strain, volume constancy and forming margin convert the displayed extremes into engineering quantities. The simulation predicts thickness changes between +1.92 % and ?27.44 %, the largest thinning being confined to the root of the rolled knuckles; this corresponds to a thickness ratio of 0.726 and a true thickness strain of ?0.321. The peak FLD map-centre value is 20.82 on a 0–100 scale, a margin of about 79 %, and no Fail or Risk zone is visible on the formed surface. The manufactured hinges were visually inspected; quantitative dimensional validation and springback measurement are identified as the principal future work.
APA:Mr. Girish Deshmukh, Associate Professor Dr. Vishnu S. Aher, Associate Professor Dr. Dipak S. Bajaj. (Volume-14, Issue-4 -(Year-Volume-14-issue-4)). Design Development, Sheet-Metal Forming Simulation and Progressive-Die Manufacturing Study of Hinges for Industrial Control Cabinets. Retrieved from https://www.ijset.in/wp-content/uploads/ICSEMT.V14_issue4_120.pdf
Chicago:Mr. Girish Deshmukh, Associate Professor Dr. Vishnu S. Aher, Associate Professor Dr. Dipak S. Bajaj. "Design Development, Sheet-Metal Forming Simulation and Progressive-Die Manufacturing Study of Hinges for Industrial Control Cabinets" Example, Volume-14-issue-4-Year-Volume-14-issue-4-2348-4098. https://www.ijset.in/wp-content/uploads/ICSEMT.V14_issue4_120.pdf.